This firmware is based upon MoTeC GPR and includes the following additional features:
-
Two stage nitrous control - various parameters supplied to control nitrous. Includes nitrous bottle heater relay control based on nitrous pressure
-
Water injection control - with fail safe for boost/timing/fuel based on pressure sensor feedback
- Boost aim strategy has been revised with flexible table setup options
- Direct control of most electronically shifted 4 speed automatics with lock-up torque converter control
- Features engine speed based traction control from GPR as well as wheel speed differential traction control (similar to the M800) for guys running automatic transmissions or any other setup where slip between the engine and the drive wheels exists.
- Trans-brake bump control also has a programmable creep feature
- Line lock control with engine speed limiter
- Cruise control
- Latch function on fuel composition sensor
- Engine starter function, including one touch auto start
- Warning and engine protection based on fuel injector duty cycle
-
Air bypass anti-lag control - for increased ALS performance (when used with appropriate engine hardware)
-
Supports the use of AEMnet lambda devices, as well as lambda controllers with a 0-5v signal output
- Supports direct input from Obsidian IMU/INS and Racegrade IMU
-
Supports direct input from a MoTeC/Racegrade CAN keypad (without pdm being present )